5th axis getting up to speed

After a little bit of calibration and tinkering in the fusion360 cps output filter files the cnc is starting to take advantage of the new 5th axis. Below is a "Flow" multiaxis toolpath finishing a sphere with a flat endmill.

There are still some issues that I have to address. It has been a surprisingly good experience so far. Starting out cutting 5 sides of a block and moving on to cutting the edges at an angle. This is the third test where I rough out the sphere using a 3d adaptive path and then use a flow multiaxis path to clean things up. Things look better in video and there is some of that to come.